ABS 3D Print

OSRAM DOT IT! Lampshade:
>>>
To provide the LED light OSRAM DOT IT with a lampshade, two casting parts and a punched diffuser foil are required. Four assembly steps are necessary whereas one of these is the removal of the aluminum case of the DOT IT.

OSRAM DOT IT!

Assembly:
>>>
The two casting parts are the lampshade itself [Matterhorn] and a hold ring which is adapted exactly on the inner life of the DOT IT. In a first step the punched diffuser foil must be stuck on the hold ring. In a second step the hold ring has to be stucked in the lampshade. In the last step the hold ring and the lampshade are stucked on the DOT IT - finished!

PROTOTYPE

Change:
>>>
By pressing the lampshade the DOT IT can be switched on and off. However a variation is also conceivable where the lampshades for the DOT IT are changeable - for this some changes have to be carried out on the DOT IT.